 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TB 11-6625-226-35/1
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR ELECTRICAL
METER TEST SET, TS-656/U
Headquarters, Department of the Army, Washington, D.C.
3 March 1966
SECTION I. GENERAL
Paragraph
Page
Purpose and scope .....................................................................
Reporting of equipment manual improvements ..........................
Description .................................................................................
General instructions ...................................................................
Differences among model ..........................................................
II. CALIBRATION
Equipment required ....................................................................
Preliminary procedure ................................................................
Dc volts ......................................................................................
Ac volts ......................................................................................
Direct current .............................................................................
Final procedure .........................................................................
SECTION I
GENERAL
Changes to DA Publications) will be used for reporting
1. Purpose and Scope. a. This bulletin provides
these improvements. This form may be completed
information for the periodic calibration of Electrical
using pen, pencil, or typewriter and forwarded direct to
Meter Test Set, TS-656/U (fig. 1) and is used by
Commanding
General,
U.S.
Army
Electronics
maintenance calibration personnel. Since calibration
Command,
ATTN:
AMSELMR-(NMP)-MTE,
Fort
personnel are trained and qualified in the usage of test
Monmouth, N. J., 07703.
and measuring equipment, detailed instructions
concerning the operation and use of these equipments
3. Description. Electrical Meter Test Set TS656/U
are not contained in this bulletin.
is a general-purpose instrument for use in tests where
b. Integrated within this bulletin are illustrations
an accurate ac or dc voltage or current is needed to
delineating the location of all controls and components
check the operation of meter movements. Additional
utilized in this calibration procedure as well as diagrams
data is listed in a through c below.
showing equipment setups.
Equipment ground
connections are not necessarily shown in the diagrams.
a. Identification.
2.
Reporting
of
Equipment
Manual
Nomenclature .....................ELECTRICAL
METER
Improvements. The direct reporting by the individual
TEST SET TS-656/U.
user, of errors, omissions, and recommendations for
Federal stock number .........6625-348-0666.
improving this bulletin is authorized and encouraged.
Line item number ...............V74464.
DA Form 2028 (Recommended
Size ...................................17 3/4 x 14 1/4 x 11 1/4 in.
Weight ...............................49 lbs.
Reference ..........................TM 11-6625-226-12 and TM
11-6625-226-35.
1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals