Final Procedure.

indication on dc voltmeter.

(3) Connect dc voltmeter between +5 volt test point

(2) Adjust R9801 (fig. 6) for 5.00 volt indication on

(fig. 6) and chassis ground. If dc voltmeter does not

dc voltmeter.

indicate between 4.95 and 5.05 volts, perform b(2)

(3) Adjust R9831 (fig. 6) for 15.00 volt indication on

below.

dc voltmeter.

(4) Repeat technique of (2) above; dc voltmeter

indication will remain between 4.95 and 5.05 volts.

(5) Connect dc voltmeter between + 15 volt test point

14. Final Procedure. a. Deenergize and disconnect all

(fig. 6) and chassis ground. If dc voltmeter does not

equipment and replace TI protective cover.

indicate between 14.85 and 15.15 volts, perform b(3)

b. In accordance with TM 38-750, annotate and affix

below.

DA Label 80 (US Army Calibrated Instrument). When

(6) Repeat technique of (2) above; dc voltmeter

the TI receives limited or special calibration, annotate

indication will remain between 14.85 and 15.15 bolts.

and affix DA Label 163 (US Army Limited or Special

b. Adjustments

Calibration). When the TI cannot be adjusted within

(1) Adjust R9851 (fig.

6) for -15.00 volt

tolerance, annotate and affix DA Form 2417 (US Army

Calibration System Rejected Instrument).

By Order of the Secretary of the Army:

E. C. MEYER

General, United States Army

Official:

Chief of Staff

J.C.PENNINGTON

Major General, United States Army

The Adjutant General

Distribution:

To be distributed in accordance with DA Form 12-34A, Requirements for Calibration Procedures Publications.

U.S. GOVERNMENT PRINTING OFFICE: 19B-6651191208