 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TM 11-7010-201-40-2/ET821-AA-MMI-020/E154 MTS/T.O. 31S5-2TSQ73-2-2
TABLE OF CONTENTS
Drawing No
Title
Sheets
Probe Assembly, Test Set - Wire List, String
Probe Assembly, Test Set - Wire List, Connector
Test Assembly, Plug-In Unit, Wired, Wire List, String
Card Rack Assembly - Analog, Wire List, String
Card Rack Assembly - Analog, Wire List, Connector
Scope. This volume contains wire lists for the test set probe assembly (drawing number WL10281447), the wired plug-in
unit test assembly (drawing number WL10281449), and the analog card rack assembly (bay 3) (drawing number
WL10281453). Refer to chapter 3 of TM 11-7010-201-34-1 for a basic explanation of wiring information and how to use
the wire lists. Also refer to sheet 2 of each wire list for notes on fabrication techniques and parts information.
NOTE
The pages in volumes 2-4 of TM 11-7010-201-40 have been numbered in a special manner. Pages within these volumes
are found by keying to two page identifiers: the drawing number and the page number. To find the page that you desire
within the volume, follow the steps listed below:
1. Find the applicable wire run list in the table of contents and note the applicable drawing number.
2. Look through the pages of the volume until you find the particular drawing number of the wire run list that you seek.
This will insure that you are in the correct wire run section.
3. Go through these pages until you find the page number you are looking for within this particular wire run list.
Remember, pages in the volumes cited above are found by keying to the drawing number applicable to a particular wire
run list, as well as, a page number. Make sure you are on the correct page by checking both page identifiers.
ii
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals