|
| |
Back
REFERENCES | Up
Engineering Symbology Prints and Drawings Volume 1 of 2 | Next
ENABLING OBJECTIVES (cont.) |
Engineering Fluid Diagrams and Prints
DOE-HDBK-1016/1-93
OBJECTIVES
TERMINAL OBJECTIVE
1.0
Given an engineering print, READ and INTERPRET facility engineering Piping and
Instrument Drawings.
ENABLING OBJECTIVES
1.1
IDENTIFY the symbols used on engineering P&IDs for the following types of valves:
a.
Globe valve
g.
Relief valve
b.
Gate valve
h.
Rupture disk
c.
Ball valve
i.
Three-way valve
d.
Check valve
j.
Four-way valve
e.
Stop check valve
k.
Throttle (needle) valve
f.
Butterfly valve
l.
Pressure regulator
1.2
IDENTIFY the symbols used on engineering P&IDs for the following types of valve
operators:
a.
Diaphragm valve operator
b.
Motor valve operator
c.
Solenoid valve operator
d.
Piston (hydraulic) valve operator
e.
Hand (manual) valve operator
f.
Reach-rod valve operator
1.3
IDENTIFY the symbols used on engineering P&IDs for educators and ejectors.
1.4
IDENTIFY the symbols used on engineering P&IDs for the following lines:
a.
Process
b.
Pneumatic
c.
Hydraulic
d.
Inert gas
e.
Instrument signal (electrical)
f.
Instrument capillary
g.
Electrical
Rev. 0
Page vii
PR-02
|
