Maintenance and Reentry Control Procedures

TM 5-4220-226-14&P 3-2. Maintenance and Reentry Control Procedures - continued. (3) 2407 Control NR: (Attach 2407) Taken from the DA Form 2407, upper left-hand comer. (4) UIC: Unit Identification Code. (5) SYSTEM: Superlite 17B Diving Helmet. (6) SUB-ASSEMBLY: The portion of the system that is being worked on. (7) COMPONENT: The part of the subassembly that will be fixed, i.e., gage isolation valve, etc. (8) S/N: Subassembly serial number. (9) P/N: Component part number. (10) FAULT ANALYSIS PERFORMED: (Describe Problem) Describe the problem and any special procedures used to isolate the problem. (11) ACTION TAKEN: (Check One) TEST:______ADJUST:______REPLACE:______REPAIR:______OTHER:______ Check the appropriate maintenance action. (12) MAINT LEVEL: Enter the single element maintenance code IAW the MAC. (13) WORK TIME: HRS. Enter the required time to complete the task (hours and tenths). (14) WORK DESCRIPTION: Describe the procedures used to perform the required maintenance. (15) OLD COMPONENT DISPOSITION: What did you do with the old part (i.e., disposed, turned Into general support for repair, etc.). (16) WAS SYSTEM INTEGRITY COMPROMISED? YES_____ NO_____ Check appropriate box. (17) IF YES, CLEANING PROCEDURE USED: Enter the cleaning procedure used. (18) WAS AIR SAMPLE TAKEN? YES_____ NO_____ ANALYSIS RESULTS: Check appropriate box and enter the analysis results. (19) REENTRY CONTROL LOG COMPLETED: (Initial) Enter initials after log entry is made. (20) WORK PERFORMED BY: Enter name, rank, title of person performing maintenance. (21) WORK CHECKED BY: Enter name, rank, title of person performing check. 3-2