Table 2-3. Donning Procedures

TM 5-4220-226-14&P Table 2-2. Predive Setup Procedures - CONT Step Procedure 4. Connect and check communications cable. a. Connect communications cable to helmet whip and wrap with tape. b. Check communications. 2-7. Donning Procedures. Table 2-3 provides the procedural steps that must be followed when donning the helmet. The experienced diver may want his (her) tender to assist in the donning procedures. However, until the procedures are well known, it is recommended that the diver dress himself (herself). This will help in the event of unforeseen emergencies. Table 2-3. Donning Procedures Step Procedure 1. Don thermal protection suit, if necessary. WARNING The hood of the wet/dry suit should never be worn inside the helmet. The neck dam seal, communi- cations, and diver's breathing will be adversely affected. 2. Don harness. Place diver's harness over his shoulder and around his chest. Don Integrated Diver's Vest Procedures are the same as harness. (IDV) (for dives deeper than 60 feet) 2-7