2-2.4.3 Routine Inspections

TM 9-6115-660-13&P 2-2.4.2 Generator Set PMCS. Generator set checks and services in the PMCS table are described as performed on a single generator set. The procedures must be performed on each of the generator sets that make up a power plant. 2-2.4.3 Routine Inspections. Use the following information to help identify potential problems before and during checks and Services. a. b. c. d. e. f. WARNING Dry cleaning solvent used to clean parts is potentially dangerous to personnel and property. Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes. Wear goggles and rubber gloves to protect eyes and skin. Wash exposed skin thoroughly. Do not smoke or use near open flame or excessive heat. Failure to observe this precaution can cause injury to personnel or damage to equipment. CAUTION Keep cleaning solvents, gasoline, and lubricants away from rubber or soft plastic parts. They will deteriorate material. Keep it clean. Dirt, grease, and oil get in the way and may cover up a serious problem. Use dry cleaning solvent to clean metal surfaces. Use soap and water to clean rubber or plastic parts and material. Check all bolts, nuts, and screws to make sure they are not loose, missing, bent, or broken. DO not try to check them all with a tool, but look for chipped paint, bare metal, or rust around bolt heads. If you find one loose, tighten it or report it to unit level maintenance. Inspect welds. Look for loose or chipped paint, rust, or gaps where parts are welded together. If a broken weld is found, report it to unit level maintenance. Inspect electrical wires, connectors, terminals, and receptacles. Look for cracked or broken insulation, bare wires, and loose or broken connectors. Tighten loose connectors and make sure wires are in good condition. Examine terminals and receptacles for service ability. If deficien- cies are found, report them to unit level maintenance. Inspect hoses and fluid lines. Look for wear, damage, and leaks. Make sure that clamps and fittings are tight. Wet spots and stains around a fitting or connector can mean a leak. If a leak comes from a loose connector, or if something is broken or worn out, report it to unit level maintenance. 2-2.5 Leakage Definitions. You must know how fluid leakage affects the status of your equipment. The following are definitions of the types/classes of leakage you need to know to be able to determine the status of your equipment, Learn and be familiar with them. When in doubt, notify your supervisor. Leakage Class Leakage Definition Class I Seepage of fluid (as indicated by wetness or discoloration) not great enough to form drops. 2-5