|
| |
Back
Figure 2-15. Remove Ground Rod | Up
TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual | Next
Figure 2-16. Disconnect Auxiliary Fuel (Typical). |
TM 9-6115-659-13&P
2-7.4
2-7.6
2-44
f.
g.
h.
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Use slide hammer to pull ground rod section (4) out of ground. Pull until second coupling
(3) is exposed.
Disconnect slide hammer from top coupling (3).
Disconnect top ground rod section (4) from bottom coupling (3).
Remove clamp (5) from ground rod (4). Store clamp in accessory box.
Connect slide hammer rod (2) to coupling (3) on ground rod section (4) still in ground.
Use slide hammer to pull second ground rod section (4) out of ground. Pull ground rod
section (4) until third coupling (3) is exposed.
Repeat steps (3) through (5) for third ground rod section (4).
Use slide hammer to pull remaining ground rod section (4) out of ground.
(10) Disconnect slide hammer rod (2) from ground rod coupling (3).
(11) Remove couplings (3) from ground rod sections (4).
Clean the couplings (3) and ground rod sections (4). Store cleaned items in accessory box.
Partially disassemble slide hammer as follows:
(1) Remove nut (6, figure 2-7).
(2) Remove hammer (5).
(3) Loosely install nut (6).
Return slide hammer to its storage location in accessory box.
Retrieve Fire Extinguisher(s). Retrieve fire extinguisher(s) and stow in bracket(s) on trailer,
Disconnect External Fuel Source. Disconnect auxiliary fuel hose as follows:
a.
b.
c.
d.
e.
Disconnect the auxiliary fuel hose (4, figure 2-16) from the generator set external fuel supply
connection (1). Elevate the free end of the auxiliary fuel hose to drain fuel back into the
external fuel source (2). Place free end of auxiliary fuel hose on a clean surface.
Disconnect auxiliary fuel hose (4) from fitting on container adapter (3).
Store auxiliary fuel hose in the generator set storage compartment below the generator set
control panel, behind the bottom-right access door.
Release the container adapter from the external fuel source by lifting the handle of the clamp
(5). Remove the container adapter from the external fuel source. Close the external fuel source
and load onto appropriate transportation.
Store the container adapter in the accessory box.
|
