|
| |
Back
2-3.3 Grounding of Generator Set. | Up
TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual | Next
2-3.4 Connecting Load |
TM 9-6115-659-13&P
Figure 2-7. Ground Rod and Slide Hammer.
a. Remove ground rod, grounding strap, and slide hammer (figure 2-7) from accessory box.
Perform assembly steps (1) through (4).
(1)
(2)
(3)
(4)
WARNING
Impact disk must be tightened to end of threads on rod. Also, lock washer
and nut must be tightened firmly against impact disk. Failure to observe
this warning could result in severe personal injury ador death and
damage to the equipment.
NOTE
The terminal lug supplied with the ground
ground strap provided with power unit.
rod is too small. Use additional
Install impact disk (3) on rod (4). Tighten impact disk to end of threads on rod (4).
Install lock washer (2) and nut (l). Tighten nut (1) and lock washer (2) securely against
impact disk (3).
If installed, remove nut (6).
Position hammer (5) on rod (4). Install nut (6) and tighten to end of threads on rod (4).
2-32
|
