TM 9-6115-604-34 NAVFAC P-8-633-34 CHAPTER 2 GENERAL MAINTENANCE INSTRUCTIONS SECTION I.  REPAIR PARTS, SPECIAL TOOLS, TEST MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT 2-1.  REPAIR PARTS.  Repair parts and equipment are tested and illustrated in TM 9-6115-604-24P, the Repair Parts and Special Tools List for the generator set. 2-2.  SPECIAL TOOLS, TEST AND SUPPORT EQUIPMENT.  Special tools, test, and support equipment are listed in Table 2-1. 2-3.  FABRICATED TOOLS AND EQUIPMENT.  Refer to Table 2-2. Table 2-1.  Special Tools, Test, and Support Equipment Reference Item NSN or Fig. No. Para No. Use Fig. Reference No. Stopwatch 403.201 5-34 Testing over/under voltage -- 5-35 relays K110/ K111 and 5-36 overcurrent relay K114. Counterboring ST-1010 -- 9-11 Sleeving water holes. -- Tool, Water Hole (15434) Tester, Hydrostatic ST-1012 Figure 9-5 9-8 Testing cylinder heads.  Requires -- (15434) 3375070 adapter plates and 3375071 packings. Driver, Rear Seal/ ST-1093 -- 9-33 Installing rear wear ring and -- Wear (15434) crankshaft seal.  Also to align seal retainer. Manometer ST-1111-3 Figure 12-1 12-3 For use with 3375767 -- (15434) manometer. Puller, Main ST-1116 -- 9-22 Removing main bearing caps. -- Bearing Cap (15434) Driver, Valve Seat ST-1122 -- 9-11 Installation of valve seat inserts. -- Insert Staking (15434) Guide, Head, ST-1134 -- 9-11 Removing dowel pins and cross- -- Dowel Pin (15434) head guides. Magnetic Crack ST-1166 -- 9-8 Testing for surface cracks in -- Detector (15434) cylinder head. Counterbore Tool, ST-1168 -- 9-31 Repairing liner counterbore in -- Liner (15434) cylinder block. Bore Tool, Main ST-1177 -- 9-31 Boring main bearing bores. -- Bearing (15434) Crankshaft ST-1196 -- 9-28 Testing crankshaft hardness. -- Hardness Tester (15434) Plate, Puller ST-1209 -- 9-24 For use with 3375629 cylinder -- (15434) liner puller. Driver Set, ST-1228 Figure 9-18 9-16 Removing and installing -- Camshaft (15434) camshaft bushings. Bushing 2-1