Installation

ARMY TM 9-6115-464-34 AIR FORCE 35C2-3-445-2 NAVY NAVFAC P-8-624-34 (i) lf winterization kits are installed, tag and disconnect electrical Ieads to engine sensors and (2) (3) (4) (5) (6) (7) (8) (9) disconnect coolant lines from engine oil pan. CAUTION Do not use a lifting device of less than 1000 lb. capacity. Failure to observe this caution could result in damage to the equipment. Attach a suitable lifting device to engine lifting brackets. Disconnect engine crankcase oil drain tube from fitting in skid base. Remove screw (1, figure 2-1), Iockwasher (2), and access cover (3). Remove screws (4), Iockwashers (5) and air inlet screen (6). Remove screws (7) and lockwashers (8), Iockplate (9) and pressure plate (10). CAUTION Take slack from hoisting sling prior to loosening generator and engine coupling bolts. Failure to observe this caution could result in damage to the equipment . Remove screws (11) and Iockwasher (12). Remove bolts (13) and Iockwashers (14). CAUTION Make a final, thorough check to ascertain that the engine is completely disconnected from the generator set prior to attempting to hoist it clear. Failure to observe this caution could result in damage to the equipment. Carefully move the engine up and forward until generator coupling disc clears engine flywheel housing. CAUTION Do not use a lifting device of less than 1000 lb. capacity. Failure to observe this caution could result in damage to the equipment. b. Installation. (1) To install engine, use a suitable lifting device to lift engine by the hooks located on the engine. (2) Carefully lower the engine (15, figure 2-1) until generator coupling and engine flywheel housing alignment matches. (3) .Alignment pins with 5/8 inch headless bolt should be screwed into holes in the flywheel to facilitate alignment. (4) Tighten down engine bolts Iecated in front of the engine to secure alignment. Torque according to paragraph 1-10y (5) Install Iockwashers (14), and bolts (13). (6) Install Iockwashers (12), and screws (11). (7) Install pressure plate (10), Iockplate (9), Iockwashers (8), and screws (7). (8) Install air inlet screen (6), Iockwashers (5), and screws (4). 2-16