|
| |
Back
Table 1-1. FITS AND TOLERANCES (CONTINUED) | Up
TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual | Next
Table 2-1. TOOLS AND SUPPORT EQUIPMENT (CONTINUED) |
ARMY TM 9-6115-464-34
AIR FORCE TO 35C2-3-445-2
NAVY NAVFAC P-8-624-34
CHAPTER 2
GENERAL MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
2-1. TOOLS AND SUPPORT EQUIPMENT.
There are no special tools or support equipment required to perform any level of maintenance on generator
set Models MEP-004A, MEP-103A, and MEP-113A. Table 2-1 contains a list of recommended tools and
support equipment normally required to maintain the generator sets at the (direct and general support) and
depot maintenance levels. References or illustrations indicating the need or use of these or similar tools areas
listed in the table.
2-2. DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS.
Direct support, general support and depot maintenance repair parts are listed and illustrated in the, Unit,
(Direct and General Support) and Depot Maintenance Repair Parts and Special Tools List).
2-3. FABRICATED TOOLS AND EQUIPMENT.
A breakdown cable is required to troubleshoot the electric governor system of MEP-113A. The breakout
cable is used to gain access to the Governor Control Unit’s MS3106R20-29 connector. Appendix B gives
fabrication instructions for the breakout cable.
Table 2-1. TOOLS AND SUPPORT EQUIPMENT
Reference
Item
FSN or Part No.
Figure
Para.
Use
Torch outfit, cutting
3433-00-357-6311 or
3-98
Removing extensively damaged
and welding (Tool
equal
housing components
Set L/W67706)
Oscilloscope
6625-00-643-1740 or
3-92
Testing voltage regulators
equal
Hoist, chain, 3 ton
3950-00–292-9879 or
2-12
2-6, 2-7
Removing and installing engine
equal
and generator assemblies
Trestle, hoist, port–
3950-00-449-7005 or
2-2,2-3
2-6,
2-7
Removing and installing engine
able, 5 ton
equal
and generator assemblies
Multimeter, split
6625-00-892-1497 or
3-95
Testing resistance of generator
core
equal
assembly windings
Multimeter, digital
6625-00-495-3513
3-65
Troubleshooting electric governor
system (MEP-113A only).
Ohmmeter
6625-00-643-1030 or
3-95
Testing continuity of generator
equal
assembly components
Puller attachment
(component of
5120-00-711-6753 or
3-95
Removing generator bearing
puller kit
equal
5180-701-8046)
Solder outfit, electric
3439-00-853-8760 or
3-95
Soldering electrical leads to
equal
generator assembly rectifiers
Test stand, actuator
4940-00-152-2107 or
3-43
Testing performance of hydraulic
equal
actuator
2-1
|
