TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Flashing Circuit (FCI) Flasher DOD Drawing Number.. ............ 76-11396 24V DC, No. 313 lamp Terminal DOD Drawing Number.. ............ 76-11241 Synchroscope Meter DOD Drawing Number..7 .......... 6-11219 Voltage ............. ....................... 120V AC, 50/60 Hz Accuracy .................................. 2 degrees Pull-in frequency ....................... 48 Hz Dropout frequency... ................. 47 Hz i.  Parallel Cable Assemblies. DOD Drawing Number.. ............ 76-11320 and 76-11321 76-11320 1200 ft (365 m) 76-11253 cable 76-11321 1200 ft (365 m) 76-11253 cable j.  Housing Kit. Actuator DOD Drawing Number.. ............ 76-11475 Voltage ............. ....................... 24V DC Load ................ ........................ 250 pounds (113.5 kilograms) Speed ............... ....................... 1.0 in/sec (25.4 mm/sec) Current .............. ...................... 7 amps 26.5V DC Relay DOD Drawing Number.. ............ 76-11444 Coil resistance ..... .................... 300 ohms .............................................. +10 percent Contact type ........ .................... DPDT with arc chamfer Contact rating ..... ..................... .10 amp resistance at 26.5V DC/ 115V AC 400 Hz with enclosure grounded Max pull-in volts........................ 18V DC Min holding volts....................... .10V DC Min dropout volt .... ................... 1V DC Operating time at... ................... 15MS max 26.5V DC Release time at ........................ 15MS max 26.5V DC NOTE Throughout    this    technical    manual    MEP-029A    is referrd to as code A and  MEP-029B is referred to as code B. 1-8. INSTRUCTION PLATES. Refer to the Operator/Crew and Organizational .Maintenance manual for location of instruction plates in the generator set. 1-9.  TORQUE DATA.  Table 1-1 lists components that require special torques. 1-10.    SCHEMATICS  AND  WIRING  DIAGRAMS.  FO-1 through FO-16 of the Operator/Crew and Organizational Maintenance   manual   are   the   schematic   and   wiring diagrams for the generator set and auxiliary equipment. 1-11.  SERIAL NUMBER EFFECTIVITY. Refer to TM5-6115-593-24P, Usable on Code data. Table 1-1.  Special Torque Data TORQUE VALUE COMPONENTS FT/LBS JOULES GENERATOR Generator mount to skid base screws 202 274 Flexible coupling to flywheel screws 112 152 ENGINE Front trunnion mounting bolts 202 274 Bell housing mounting bolts 296 401 Main bearing capscrew Tighten to 200 min/210 max 271min/285 max Advance to 410 min/420 max 555 min/570 max Loosen         all Tighten to 200 min/210 max 271 min/285 max Advance 420 min/460 max 570 min/624 max * Applicable to Generator Set serial numbers FZ00001-FZ00064 only * Cap screw should be coated with 30 weight oil 1-5