|
| |
Back
Figure 2-9. Preparation for Starting with Housing Kit Installed (Sheet 2 of 3) | Up
TM-5-6115-593-12 Power Plant Utility (MUST) Gas Turbine Engine Driven (AMERTECH Corp Model APP-1) Manual | Next
Figure 2-10. Starting Instructions when Ambient Temperature is from 40°F to -25°F (4.4°C to -32°C) and Housing Kit is Installed (Sheet 1 of 3) |
TM 5-6115-593-12
TO 35C2-3-463-1
WARNING
DO NOT OPERATE THE GENERATOR SET UNLESS THE GROUND TERMINAL STUD HAS BEEN
CONNECTED TO A SUITABLE GROUND. ELECTRICAL FAULTS IN THE GENERATOR SET, LOAD
LINES OR LOAD EQUIPMENT, CAN CAUSE INJURY OR LOAD LINES OR LOAD EQUIPMENT, CAN
CAUSE INJURY OR ELECTROCUTION WITH AN UNGROUNDED SYSTEM.
WARNING
MAKE SURE THAT NO TOOLS, PARTS OR LOOSE ITEMS ARE ON ANY PART OF THE ENGINE
SINCE THEY MIGHT CAUSE BODILY HARM TO PERSONNEL WHEN THE ENGINE IS STARTED.
CAUTION
IF ENGINE DOES DOT START IN 45 SECONDS, OVERCRANK PROTECTION WILL TERMINATE THE
CRANKING CYCLE. RESET AND ALLOW 1-MINUTE REST BEFORE STARTING ANOTHER CRANK
CYCLE.
Figure 2-9. Preparation for Starting with Housing
Kit Installed (Sheet 3 of 3)
2-22
|
