TM-5-6115-585-12

TM5-6115-585-12 NAVFAC P-8-623-12 TO-35C2-3-455-1 TM-05684C/05685B-12 Figure 3-17. Engine Cooling Assembly (Sheet 2 of 2) 3-23. GENERATOR ASSEMBLY. On ASK equipped generators, inspection is limited to screen guard areas visible through access doors. Inspect screen guard (3, figure 3-18) to see that it is clean and free of Figure 3-18. Generator Assembly debris and free of dents or cracks. Check that screen-guard is securely fastened in place over opening in generator housing-stator assembly. Inspect end-bell (2) to see that it is clean and free of cracks or other physical damage. Check that openings in end-bell and end-bell cover are free of debris. Check that end-bell is securely attached to generator housing. 3-24. ENGINE ASSEMBLY. a. Lifting Attachment (sea figure 3-17). On ASK equipped generators, open air intake door. Inspect for cracks or other physical damage. Check that mounting screws (37) are secure. NOTE On ASK aquipped generators, if intake manifold is suspected of possible problems, refer to higher level of maintenance. b. Intake Manifold Assembly (see figure 3-19). Inspect intake manifold (1) for cracks or physical damage. Check that manifold is properly secured to cylinder head and mounting screws (5) and lock tabs (3) are in place. c. Oil Drain Hose (see figure 3-20). On ASK equipped generators, remove oil access door. Inspect oil drain hose for physical damage. Check that drain valve operates properly and does not leak when closed. Check that oil drain hose is properly stored when not in use. d. Engine Mounting Assemblies (Two) (see figure 3-19). On ASK equipped generators, remove oil access door and batteries access door. Inspect engine mounts (13) for deterioration or physical damage. Check for accumulation of dirt, fuel, or oil. Check that mounts are securely attached to engine and to skid- bsse with all mounting hardware in place. Change 8 3-23