|
| |
Back
Figure 3-1. Engine Cooling System | Up
TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual | Next
CHAPTER 4 MAINTENANCE OF FUEL SYSTEM |
The high temperature cutout switch must be
removed and tested semiamually (500 hours),
b. Test.
(1) Using an oil pot tester and peanut oil, heat
oil to 394° ± 10 ° F (201° ± 5 ° C).
(2) Immerse threads and bottom surface of switch
in oil. After a minimum of 1 minute, use an ohm-
meter and check continuity between terminals on
switch.
TM 5-6115-584-34
NAVFAC P-8-622-34
TO-35C2-3-456-2
TM--0568C-34
(3) If continuity exists, replace with a new switch.
(4) Keep threads and bottom surface of switch in
oil and allow it to cool to 300° F (149° C ) minimum.
Repeat continuity check in (2) above.
(5) If continuity does not exist, replace with a
new switch.
c. Installation.
(1) Install switch (11) on engine and lock with
locking tab (12).
(2) Connect electrical leads (10) to switch ter-
minals.
(3) On ASK equipped generators, refer to Operator and
Organizational Maintenance Manual and replace exhaust
plenum and top panel assembly.
Change 6
3-3/(3-4 blank)
|
