TM 5-6115-584-34 2-3.   Troubleshooting — MALFUNCTION INSPECTION CORRECTIVE — 1. STARTER MOTOR TURN-HIGH CURRENT DRAW. starter grounded terminals,  or 5-2). Replace component. Check  for  frozen  armature bushing   (paragraph bushing   and.   if   necessary,   armature. STARTER DOES NOT TURN-NO D.RAW. Step  1.  Check  for  open  armature  windings  (paragraph Replace  armature  if  necessary. Step  2.  Check  for  open  starter windings   (paragraph   5-2). Replace  field.  windings  if  necessary. Step  3.  Check  for or  weak  brush  springs 5-2). Replace   brush   springs necessary. Step  4.  Check worn (paragraph   5-2). 3. SLOW STARTER SPE ED. Step  1.  Check  for  dirty  commutator  (paragraph  5-2). Clean  or refinish   commutator. Step Check  for   worn   armature   shaft   bushings   (paragraph   5-2). Replace   bushings   and, necessary,   armature. Step  3.  Check  for  burned  solenoid (paragraph   5-2). Replace 4.  Check  for  open shorted   starter   field   windings   (paragraph   5-2), Replace  windings necessary. Step  5.  Check  for  shorted  generator (paragraph   8-2). Replace   stator   windings. Step  6.  Check  for  worn  generator  end  bearing  (paragraph Replace  bearing  if  necessary. Step Check   for engine   crankshaft,    rod,   and   camshaft   bearings   (paragraph   7-17). Replace    bearings    as    necessary.    Repair  or  replace worn   components as   necessary. 2-6 Change 5