Table 2-2. Fabricated Tools and Equipment (Cont)

TM 5-6115-584-34 NAVFAC P-8-622-34- TO-35C2-3-456-2 TM-0568C-34 Table 2-2. Fabricated Tools and Equipment (Cent) Nomenclature Reference No. orNSN Material Required Crankshaft gear puller ring Steel, round, CD Fabrication 11’ArUCtiOIIS: Make pulleraccording to dimensions shown below. Sketch or Diagram: ‘<’’”-t-% //’_ 3 HOLES .19 DIA. 2 HOLES .28 DiA. 3.00 \ — 1 . 1 3 -— I \ BOLT CIRCLE .50 1+ 1 1- R AD IUS L 3.CO Section II. TROUBLESHOOTING 2-4. GENERAL. 2-5. MALFUNCTIONS NOT CORRECTED BY USE OF THE TROUBLESH~T~G TABLE. This section contains troubleshooting information for locating and correcting operating troubles which may develop in the Generator Set. Each malfunction for an individual component unit, or system is followed by a This manual cannot list all malfunctions that may list of tests or inspections which will help you to occur, nor all tests or inspections and corrective determine probable causes and corrective actions to actions. If a malfunction is not listed or cannot be take. You should perform the test.+ inspections and corrected by listed corrective actions, notify your corrective actions in the order listed. supervisor. Change 5 2-5 .- —