Section II. MOVEMENT TO A NEW WORKSITE

TM 5-6115-584-12 NAVFAC P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 Section II. MOVEMENT TO A NEW WORKSITE 4.3 DISMANTLING GENERATOR SET FOR MOVE- MENT. a. Preparation for Movement. (1) Disconnect the load cables. (2) Remove exhaust pipe extension if used. (3) Make certain vent on underside of fuel filler cap is closed. (4) Refer to the Items Troop Installed or Authorized List (Appendix B and make sure all items are on the equipment. (6) On ASK equipped generators, remove batteries access door. Disconnect negative battery cable from battery. (7) Disconnect any other hoses, lines or cables, if used. (8) Close and secure all doors and panels. b. Movement. Preferred means of movement is to transport. Towing for short distance is permissible if terrain is suitable. 4-4. REINSTALLING GENERATOR SET AFTER MOVE- MENT. (5)Disconnect the ground lead from the ground stud. Refer to paragraph 4-2 for reinstallation after movement to a new worksite. Section III. REPAIR PARTS; SPECIAL TOOLS; SPECIAL TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT AND SPECIAL SUPPORT EQUIPMENT 4-5. SPECIAL TOOLS AND EQUIPMENT. 4-6. MAINTENANCE REPAIR PARTS. Special tools are listed in Appendix D, Section Ill. Repair parts and equipment are listed and illustrated in the repair parts and special tools list manual covering organizational maintainenace for this Gener- ator Set. Section IV. LUBRICATION INSTRUCTIONS 4-7. LUBRICATION. a. Lubrication Order. Lubrication instructions for the Generator Set are contained in L05-6115-564-12. (F) Air Force lubrication instructions appear in the applicable work card set in the TO 35C2-3-1-428 series. NOTE Insure that crankcase is hot before draining oil. (b) Oil Change (see figure 3-20). On ASK equipped generators, remove oil access door. (5) Open drain plug (1, figure 4-30) and drain oil filter oil into a container having at least a 1 quart capacity. (6) Remove through bolt (2) and Pull oil filter body (3) loose from oil filter adapter (5). (7) Discard gasket (4) and oil filter element (6). (8) Wipe inside of oil filter body (3) clean with a rag. (1) With drain valve closed, disconnect oil drain hose from the plug on the skid-base. (2) Open drain valve and drain oil into a con- tainer having at least a 7 quart capacity. (3) Close drain vaive. (4) Connect oil drain hose to plug on skid-base. 4-4 Change 7 (9) Wipe inside of adapter (6) clean with a rag. Insure the gasket groove is free of foreign material. Inspect gaskets (7) and (10) tO b e s u re they are not torn or frayed. Check that retainer (8), and spring (9) are not deformed. Replace damaged components.