|
| |
Back
Figure 3-17. Engine Cooling Assembly | Up
TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual | Next
Figure 3-19. Intake Manifold Assembly |
TM 5-6115-584-12
NAVFAC P-8-622-12
TO-35C2-3-456-1
TM-05682C-12
1. Screw (6)
22. shroud
2. Air duct cover
23. Nut
3. Screw (4)
24. Hook bolt
4. Shutter assembly
25. Baffle
5. Connector
26. Screw (3)
6. Clamp
27. Retainer (3)
7. Screw (4)
28. Cover
8. Washer (4)
29. Grille
9. Door panel and shroud assembly
30. Screw (5)
10. Rivet (3)
31. Screw (3)
11. Shroud
32. Blower housing
12. Door panel
33. Screw
13. Screw (4)
34. Screw
14. Latch (2)
35. Clip
15. Screw (2)
36. Shroud
16. Lockwasher (2)
37. Lifting eye
17. Screw
38. High temperature cutout switch
18. Screw (4)
39. Lock tab
19. Tie bar (2)
40. Muffler
20. Screw (4)
41. Oil pressure gauge
21. Tie bar
TS 6115-584-12/3-14(2)
Figure 3-17. Engine Cooling Assembly (Sheet 2 of 2)
3-23. GENERATOR ASSEMBLY.
On ASK equipped generators, inspection iS limited to
screenguard areas visible through access doors. Inspect
screenguard (3, figure 3-18) to see that is clean and free of
Figure 3-18. Generator Assembly
debris and free of dents or cracks. Check that screen-guard
is securely fastaned in place over opening in generator
housing-stator assembly. Inspect end-bell (2) to see that it is
clean and frae of cracks or other physical damage. Check
that openings in end-bell and end-bell covar are free of
debris. Check that end-bell is securely attached to generator
housing.
3-24. ENGINE ASSEMBLY.
a. Lifting attachment (see figure 3-17). On ASK equipped
generators, open air intake door, Inspect for cracks or other
physical damage. Check that lifting eye (37) is securely
mounted.
b. Intake Manifold Assembly (see figure 3-19). On ASK
equipped generators, if intake manifold is suspected of possible
problems, refer to higher level of maintenance. Inspect intake
manifold (1) for cracks or physical damage. Check that manifold
is properly secured to cylinder head and mounting screws (5) and
lock tabs (3) are in place.
c. Oil Drain Hose (see figure 3-20). On ASK equipped gener-
ators, remove oil access door and inspect oil drain hose for
physical damage. Check that drain valve operates properly and
does not leak when closed. Check that oil drain hose is properly
stored when not in use.
d. Engine Mounting Assemblies (see figure 3-19). On ASK
equipped generators, remove oil access door and batteries
access door. Inspect engine mounts (13) for deterioration or
physical damage. Check for accumulations of dirt, fuel, or oil,
Check that mounts are securely attached to engine and to skid-
base with all mounting hardware in place.
Change 7
3-23
|
