Table 2-1. Generator Set Controls and Instruments (Cont)

Figure 2-1.. Load Terminals Figure 2-1. Figure 2-2. TM 5-6115-584-12 NAVFAC P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 Table 2-1. Generator Set Controls and Instruments (Cont) Control Description Function OIL PRESSURE Located on oil fill side of engine. Indicates engine oil pressure. GAUGE 0-50 pounds per square inch (psi) RECONNECTION Located on output control box. Used to select 120V, 1 phase; 120/240V, 1 phase; or SWITCH Three position rotary switch. 120/208V, 3 phase output for Generator Set. c. Place master switch in START position and hold until engine comes to operating speed. If engine does not start within 15 seconds repeat steps b and c. NOTE If engine does not come to operating speed within 15 seconds, a minimum of 30 seconds cooling period must be observed before attempting another start. d. Master switch will return to PRIME & RUN position when released. If running from auxiliary fuel source, move master switch to PRIME & RUN AUX. FUEL position. e. Check oil pressure on engine mounted gauge. Oil pressure should be at least 20 psi minimum. Check frequency on frequency meter on control panel and adjust governor if necessary, using speed control. Frequency meter should read 61.5 with no load. Pull- ing speed control knob out will increase frequency, Change 6 2-3