Section III. CONTROLS AND INSTRUMENTS

Section II. MOVEMENT TO NEW WORKSITE 2-7. Dismantling for Movement. WARNING Make certain that engine generator set is not operating in a standby mode, or con- nected to a parallel bus. a. Preparation for Movement. (1) Disconnect the load cables from the load terminal board (fig. 2-3) and tag for identifica- tion. (2) Remove the exhaust pipe extension, if used . (3) Drain fuel (fig. 3-7) and coolant (para 3-41) if transportation by railroad is anticipated or the distance to be traveled is great. (4) Refer to the basic issue item list (Appendix B) and make sure that all items are present and properly stowed. (5) Disconnect the ground lead from the ground terminal stud (fig. 2-2). (6) Disconnect any other external hoses, lines and cables, if used. (7) Close and secure all doors and panels. b. Movement. (1) If the engine generator set is to be moved only a short distance and the terrain is suitable, attach a suitable towing device to the towing openings of the engine generator set and tow the engine generator set to the new worksite. (2) If the engine generator set is to be moved a long distance, or if the terrain is unsuitable for towing, prepare engine generator set for moving as described in paragraph 2-7 a. 2-8. Reinstallation after Movement. Refer to paragraph 2-5 for reinstallation after movement to a new worksite. Section III. CONTROLS AND INSTRUMENTS 2-9. General. 2-10. Controls and Instruments. This section describes and illustrates the various The purpose of the generator set controls and controls and instruments required for generator instruments and the normal and scale readings of set operation. the instruments are illustrated in figure 2-5. 2-10