Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS

TM 5-6115-400-35

terminal of the output receptacle and the lower contacts

of the cutout relay. See figure 2.

26. Replacement of Suppression Components

Refer to figure 2 and replace the radio interference

suppression components.

Figure 2. Radio Interference suppression

components.

Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS

27. Housing

a. Removal. Refer to figure 3 and remove the

(1) See figure 3 and remove housing top and

housing.

rear side covers, louver doors, and

louvers.

b. Installation. Refer to figure 3 and install the

housing.

(2) Remove paralleling receptacles (located

near control panel).

28. Engine

a. General The engine is supported in front by the

(3) Remove relay box to control panel wiring

front mounting bracket (fig. 4) secured to a cross

harness.

member of the generator set base. The engine is

(4) Remove 120 VAC outlet plugs (located

supported in the rear by the main generator which is

near control panel).

bolted to supporting plates welded into the generator set

(5) Cut wire connections to fuse holder

base.

(located between 120 VAC outlet plugs

b. Removal.

and paralleling receptacles). These wires

Note

must be reconnected and soldered for

To remove the engine, it is necessary

reassembly.

to remove the engine and generator

(6) Disconnect all wiring harnesses from the

as an assembly and separate the

control panel.

engine from the generator after

(7) Disconnect harnesses from the electric

removal. However, the generator can

governor control unit.

be removed with the engine in the

set.