Click here to make tpub.com your Home Page

Page Title: Table 1. Engine Repair and Replacement Standards-Continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
 Advancement
 Aerographer
 Automotive
 Aviation
 Construction
 Diving
 Draftsman
 Engineering
 Electronics
 Food and Cooking
 Logistics
 Math
 Medical
 Music
 Nuclear Fundamentals
 Photography
 Religion
   
   

 
Back
Table 1. Engine Repair and Replacement Standards-Continued		Up
TM-5-6115-400-35 Generator Set Diesel Engine Driven 200 KW 60 Cycle AC 120/208V 240/416V 3 Phase Convertible to 167Kw 50 Cycle 120/208V 240/416 V Manual		Next
Chapter 2. GENERAL MAINTENANCE INSTRUCTIONS

TM 5-6115-400-35
Table 1. Engine Repair and Replacement Standards-Continued
Manufacturer'
s
Maximum
Component
dimensions and
Desired
allowable
tolerance in
clearance
wear and
inches
clearance
Min.
Max.
Min.
Max.
Drive gear
O.D. of shaft for drive par .........................................
1.2505
1.2516
Bore in drive gear for shaft ........................................
1.2495
1.2500
Fit-shaft to gear .....................................................
------------
------------
0.0005
0.0020
...............................................................................
tight
Gear-upper shaft
O.D. of shaft for upper shaft gear .............................
0.7500
0.7505
Bore in gear for upper shaft ......................................
------------
------------
0.0000
0.0010
Fit-shaft-to-gear ........................................................
0.7495
0.7500
0.0000
tight
Gear-lower shaft
O.D. of shaft for lower shaft gear ..............................
1.2505
1.2515
Bore in gear for lower shaft ......................................
1.2495
1.2500
Fit-shaft to gear .........................................................
------------
------------
0.0006
0.0020
...............................................................................
tight
End play-upper and lower shafts ...............................
------------
------------
0.0020
0.0050
Auxiliary pump drive
O.D. of shaft for housing ...........................................
0.7510
0.7516
Bore in housing for shaft ...........................................
0.7495
0.7505
Fit-shaft-to-bore in housing .......................................
------------
------------
.0005
.0020
...............................................................................
tight
O.D. of shaft for bushing ..........................................
0.8720
0.8780
O.D. of bushing .........................................................
1.0025
1.0035
Bore in gear for bushing ............................................
0.9996
1.0005
I.D. of bushing installed ............................................
0.8745
0.8755
Fit-bushing-to-bore in gear ....................................
------------
------------
0.0020
0.0040
...............................................................................
tight
Shaft-to-bushing in gear clearance ...........................
------------
------------
0.0015
0.0085
Figure 1. Schematic wiring diagram.
g. Schematic Wiring Diagram. figure 1 shows the
(Located at back of manual)
schematic wiring diagram for this generator set.
11

Privacy Statement - Press Release - Copyright Information. - Contact Us