OIL FILTER

LO 9-6115-464-12

2 . OIL FILTER. Every 300 hours remove filter element, clean housing, install new element, fill crankcase, operate

engine for 5 minutes, check for leaks, check crankcase oil level, and bring to FULL mark. Oil filter replacement

interval shall aline with on-condition AOAP or hard time oil change requirements. See notes 7 and 8.

3 . OIL CAN POINTS. Every 100 hours lubricate the hinges, latches, control linkages, and all exposed adjusting

threads with OE/HDO.

4 . HYDRAULIC SUMP. To drain, remove hydraulic lines from actuator and drain oil into a suitable container.

Replace hydraulic line, fill tank, and check level.

5 . CRANKCASE. Crankcase level maybe checked with the engine in either a static or operating condition.

6 . HYDRAULIC FILTER, HYDRAULIC ACTUATOR FILTER , AND HYDRAULIC SUMP. Precise sets only.

7. CRANKCASE OIL. A sample of the oil shall be sent to an AOAP laboratory for analysis at an interval of 50

h o u r s or 60 days. Refer to TB43-0210 for sampling requirements.

8. When AOAP laboratory support is not available, drain and refill crankcase oil and change the oil filter at 300

hours or 6 months.

9 . For arctic operation refer to FM 9-207.

copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are

mandatory.

Card 3 of 4