 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  LO 5-6115-622-12
LOP8-635-12
Table 1. Lubricant Table
1.
Check crankcase sight indicator on right hand side of pan. Add oil as required.
2.
Generator set must be shut down to grease generator G2 main bearing.
3.
Clean fittings before lubricating. Lubricate with grease gun.
4.
Change lubricating oil when replacing filters. Prime lube system. Refer to TM 5-6115-622-12 Chapter 3, for
procedure. Oil gasket of new filter before installing. Observe filter for 15 minutes after installation to verify good seal.
Remove filter and oil gasket again if leaks are observed.
5.
GF = Grease fitting.
6.
For arctic operation refer to TM 9-207.
A copy of this lubrication order will remain with the equipment at all times; instructions herein are mandatory.
Card 3 of 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals