Click here to make tpub.com your Home Page

Page Title: LUBRICATION ORDER - GENERATOR SET, DIESEL ENGINE DRIVEN, SKID MTD., 200 KW (CONT)
Back | Up

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
LUBRICATION ORDER - GENERATOR SET, DIESEL ENGINE DRIVEN, SKID MTD., 200 KW
Up
LO-5-6115-458-12 Generator Set Diesel Engine Driven Skid Mtd. 100 KW 3 Phase 4 Wire 120/208 and 240/ 416 Volts Manual

LO 5-6115-458-12
*The time specified is the time required to perform all services
at the particular interval (On-condition or hard time).
*TOTAL TASK - HR
*TOTAL TASK - HR
INTERVAL
TASK - HR
INTERVAL
TASK - HR
8
0.1
50H or 60D
0.6
100
1.2
1000
1.0
- KEY -
EXPECTED TEMPERATURES
ABOVE +32° F
°
+40° F TO -10° F
°
°
0° F TO -65° F
°
°
LUBRICANTS
CAPACITY
INTERVALS
(ABOVE 0° C)
°
(+5° C TO -23° C)
°
°
(-18° C TO -50° C)
°
°
LUBRICATING OIL,
OE/HDO
(MIL-L-2104D)
Engine
Engine Crankcase
Intervals
OE/HDO 30
OE/HDO 10
with Filters
48 qts (45.6L)
given are
OR
OR
OEA
Oil Can points
in hours of
LUBRICATING OIL,
OEA
OE/HDO 15-40
OE/HDO 15-40
normal
(MIL-H-46167)
Engine, Subzero
operation
HYDRAULIC FLUID
OHA
(MIL-H-5606B)
Hydraulic Tank
Filters and Lines
8 qts (7.6L)
ALL TEMPERATURES
NOTES:
1.  FOR OPERATION OF EQUIPMENT IN PROTRACTED
6.  CRANKCASE OIL. A sample of the oil shall be sent
COLD TEMPERATURES BELOW -10° F (-23° ).  Remove
to an AOAP laboratory for analysis at an interval of 50
hours or 60 days.  Refer to TB 43-0210 for sampling
lubricants prescribed in the key for temperatures above
requirements.
-10° F (-23° C).  Clean parts with dry-cleaning SOLVENT
(SD), type II or equivalent.  Lubricate with lubricants
7.  When AOAP laboratory support is not available,
specified in the key for temperatures 0° F to -65° F.
drain and refill crankcase oil at 300 hours or 6 months.
2.  OIL CAN POINTS. Every 100 hours lubricate hinges,
Copy of this Lubrication Order will remain with the equipment
latches, control linkages, and all exposed adjusting
at all times; instructions contained herein are mandatory.
threads with OE-HDO.
3.  Crankcase oil level may be determined while engine
By Order of the Secretary of the Army;
is running.
4.  ENGINE OIL FILTER. Every 300 hours remove filter
element,  clean  housing,  install  new  element,  fill
CARL. E. VUONO
crankcase, operate engine for 5 minutes, and check
General, United States Army
housing for leaks, Shut down engine, check crankcase oil
Chief of Staff
level, and bring to full mark.  Oil filter replacement
Official:
interval shall aline with on-condition AOAP or hard time
oil change requirements. See notes 6 and 7.
5.  SET DIFFERENCES. Used on precise generator sets
R. L. DILWORTH
only.
Brigadier General, United States Army
The Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25A,
Operator and Unit Maintenance requirements for Generator
Set, 120/208V, 240/416V, 200 KW, 3 PH, 4 Wire (MEP-009A,
MEP-108A).
020612-000
LO 5-6115-458-12
U.S. GOVERNMENT PRINTING OFFICE : 1999 O - 454-099 (80448)
CARD 2 OF 2

Privacy Statement - Press Release - Copyright Information. - Contact Us