TM 5-3810-306-34
REASSEMBLY
CAUTION
1. ASSEMBLE COLLECTOR CORE (2).
Ensure brush and arms assemblies
are installed in proper order.
a. If removed, install studs (4) in holder (40).
CAUTION
b. If removed, install retaining plate (6) on
cam plate (32) and tighten clamps (42).
Ensure that any brush and arm
assemblies that have been replaced
c. Install cam plate (32) and retaining plate
are of proper electrical capacity.
(6) on collector core (2).
NOTE
d. Install spacer ring (39).
When installing brush and arm
e. Install collector rings (10) and (11),
assemblies, do not unhook springs.
Use your fingers to spread brush
arms while sliding brush and arm
f. Install bearing (5) on studs (4) and secure
assemblies onto holding studs.
with nuts (3).
4. INSTALL BRUSH AND ARM ASSEMBLIES (26)
2. INSTALL COLLECTOR CORE (2).
AND (27).
a. Install nylon bearing (25) in mounting
5. INSTALL ANY SPACERS THAT WERE TAKEN
bracket (23).
OFF.
b. Install collector core (2) in mounting
6. INSTALL WASHERS (7) AND NUTS (14) ON
bracket (23) and tighten one setscrew to
STUDS (13).
secure core to center post (8). (This
setscrew will be loosened later).
NOTE
NOTE
Tighten nuts (14) snugly insuring that
brush and arm assemblies move
When assembling switch (31), ensure
freely.
switch wiper (46) allows switch to
make contact when in detent. Do a
7. CONNECT KNIFE DISCONNECTS ON BRUSH
AND ARMS ASSEMBLIES. SLIDE PLASTIC
SLEEVES OVER KNIFE DISCONNECTS.
3. INSTALL CAM
ROLLER
ARM
(36)
AND
SWITCH (31).
END OF TASK
15-104