TM 5-3810-306-34
c.
Lubricate new rubber seal (3) and install it on
the compressor gradually until springs and
cap (2).
vanes are in position they will occupy while in
cam ring.
9. INSTALL END CAP (2).
f.
Place backup plate, slightly smaller than outside
a. Press needle bearing (4) into end cap (2) with
bearing 0.0625-in. (1.58 mm) below face of cap.
rotor, springs, and vanes into cam ring. The
backup plate will prevent vanes from sliding end
b. Position end cap (2) over dowel pin (5). Hold the
wise in rotor slots and damaging slots and
end cap firmly against cam ring assembly and
springs.
rotate to line up bolt holes.
8. INSTALL CAM RING (6).
c.
Insert capscrews (1) and tighten evenly to 130 ft-
lbs (173 Nm).
a. Thread two 1/4-20 screws into cam ring
assembly on the same side of the ring that
10. INSTALL HOIST MOTOR. (REFER TO PAGE 15-
indicates cam size.
b. Insert dowel pin (5) in cam ring and position
END OF TASK
complete assembly in body over other dowel pin
(11). DO NOT SEAT.
15-59