TM 5-3810-306-34
WARNING (Cont'd)
excessive heat. The flash point is
100F138F (38-59C). If you become
dizzy while using cleaning solvent,
get fresh air immediately and get
medical aid. If contact with eyes is
made, wash your eyes with water and
get medical aid immediately.
Compressed air used for cleaning
purposes will not exceed 30 psi. Use
only with effective chip guarding and
personal
protective
equipment
(goggles/shield, gloves, etc.).
1. CLEAN PARTS WITH SOLVENT P-D-680 AND
DRY WITH COMPRESSED AIR.
INSPECTION:
1. INSPECT SHIFTER FORK (3) FOR WEAR AND
c. Install shaft (11) secure to shifter fork (3)
DISTORTION.
with spring pin (9).
2. INSPECT
SHIFTER
BUTTONS
(15)
FOR
d. Install fittings (4), (5) and (6) into pump
WEAR.
disconnect.
3. INSPECT SHAFT FOR EXCESSIVE WEAR.
e. Position collar (10) on shaft (11) and
secure with spring pin (7).
4. INSPECT DRIVE SLEEVE (2) FOR WEAR AND
CRACKS.
f. Position handle (12) on shaft and secure
with spring pin (8).
REASSEMBLY:
g. Install knob (14) on handle (12).
1. REASSEMBLE PUMP DISCONNECT (1).
2. INSTALL PUMP DISCONNECT ASSEMBLY.
a. Install two new oil seals (13).
b. Install shifter fork (3) and position so shaft
END OF TASK
(11) can be installed through shifter fork
(3).
13-43