TM 5-3810-306-34
OUTRIGGER EXTENSION CYLINDER INSTALLATION
SUPPLIES:
EQUIPMENT CONDITION: Outrigger beam removed. (Refer to page 11-2.)
REMOVAL:
1. REMOVE CLEVIS PIN (1) AND EXTENSION
CYLINDER (3).
a. Remove cotter pins (2) and pin (1) securing rod
end of extension cylinder (3) to outrigger beam.
Discard cotter pins (2).
b. Withdraw cylinder until rod end is exposed.
c.
Tag and disconnect hydraulic lines (4) on rod
end of extension cylinder. Remove and discard
packings (13). Cap lines.
d. Remove extension cylinder (3).
washers (7), nuts (5), spacer (10) and clamps
(8) and (9).
f.
If necessary, remove fittings (12) from end of
cylinder. Remove and discard packings (14).
Plug ports.
INSTALLATION:
1. INSTALL FITTINGS (12) AND CLAMPS (8) AND (9)
ONTO EXTENSION CYLINDER (3).
11-8