TM 10-3930-675-24-2
CAB SLIDING CYLINDER REPLACEMENT - CONTINUED
0174 00
REMOVAL
1.
Disconnect two hydraulic hoses (3) from cylinder (8). Cap or plug all openings.
2.
At end of cylinder (8), remove pin (1).
3.
At opposite end of cylinder (8), remove screw (7), washer (4), and shaft (6).
4.
Remove cylinder (8) from mounting brackets (5 and 9).
5.
Remove two fittings (2) from cylinder (8).
1
4
3
3
2
8
6
9
8
7
5
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
Install two fittings (2) on cylinder (8).
2.
Align end of cylinder (8) to mounting bracket (5) so shaft (6) can be installed.
3.
Apply a thin coat of grease to shaft (6) and install cylinder (8) with shaft.
4.
Install washer (4) and screw (7).
5.
Apply a thin coat of grease to pin (1).
6.
At opposite end of cylinder (8), align cylinder to mounting bracket (9) and install pin (1).
7.
Remove caps/plugs and connect two hydraulic hoses (3) to cylinder (8).
8.
9.
10.
Start engine (TM 10-3930-675-10).
11.
Check for leaks and proper operation of cab sliding cylinder (TM 10-3930-675-10).
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0174 00-2