|
| |
Back
Option 6: High-Pressure Line Repair (Hose and Tube Splice) | Up
TM-9-2320-356-BD Truck Tractor Line Haul: 52 000 GCWR 6x4 M915A3 Manual | Next
Procedural Steps |
TM 9-2320-356-BD
Option 7:
High-Pressure Line Repair (Same Size Line End).
Procedural Steps:
1.
Measure desired length of hose.
Tape and mark area to be cut.
2.
Squarely cut hose and remove loose particles and tape.
3.
Install sleeve over hose cover.
4.
Apply light coat of sealing compound on threads of nipple. Install nipple
between hose cover and inner tube.
5.
Install sleeve on nipple and tighten.
6.
Record the BDAR action taken.
When the mission is completed, as soon as
practicable,
repair using standard maintenance procedures.
3-34.
HYDRAULIC TUBE AND HOSE ISOLATION
General Information:
These procedures tell how to isolate damaged hydraulic tubes and hoses. Use the
following options to plug or seal a damaged hydraulic circuit so that the rest of
the system can operate without losing fluid.
Option 1:
Low-Pressure Hose Isolation.
Limitations:
o Not recommended for pressure above 70 psi
3-31
|
