 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-4. ENGINE ASSEMBLY - REPLACE
This task covers:
a. Removal
b. Installation
c. Place in Service
INITIAL SETUP
Applicable Configurations
Personnel Required
MOS62B
All
Materials/Parts
Common Tools
Gasket (29)
Shop Equipment General Purpose
Seal (25, 33)
Repair; Semi-Trailer Mounted
Lubricating Oil OE/HDO-30 (See
NSN 4940-00-287-4894
LO5-241O-237-12)
Lifting Equipment (capacity
Wire I.D. Tags
3000 lb.)
Oil pan
Spreader Bar (length approx. 43"
Cotter Pin (12)
capacity 3000 lb.)
Engine Stand (capacity 3000 lb.)
Preformed Packing (52)
Equipment Condition
Engine oil drained. See TM5-
Fuel supply valve turned "OFF".
2410-237-20.
Hood removed. See TM5-241O-237-2O.
Radiator guard removed. See
Drive shaft removed. See TM5-
2410-237-20.
page 11-40
Air cleaner dust ejector removed.
Fan guard removed. See page 5-21.
Dash removed. See page 11-8.
See TM5-241O-237-2O.
Start receptacle removed. See
Floor plates removed. See TM5-
TM5-241O-237-2O.
2410-237-20.
Winch pump removed (if equipped).
Crankcase guards removed. See
See TM5-241O-237-2O.
TM5-241O-237-2O.
Hydraulic tank drainned. See
Transmission oil drained. See
TM5-241O-237-2O.
TM5-241O-237-2O.
Hydraulic oil pump removed. See
Transmission oil filter assembly
TM5-241O-237-2O.
removed. See TM5-241O-237-2O.
a.
Removal
NOTE
Tag wires and cables for installation.
(1) Tilt operator's seat forward and
disconnect STE/ICE wire (1) from
battery disconnect switch using
a wrench.
3-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals