Figure 6. Drilling rear gladhand bracket holes

MWO 9-2320-287-35

M e a s u r e and mark one 1-3/4 inches (4.5 cm) inward from edge of rear frame

rail (7), 2 inches (5.1 cm) rearward from the front crossmember (8).

l . D r i l l one 5/16 inch (7.9 mm) diameter hole where the two marks on the

c r o s s m e m b e r (8) cross each other.

Figure 6. Drilling rear gladhand bracket holes

m. Secure gladhand bracket (9) (Table 2, item 11) to crossmember (8) with cap-

screw (10), (Table 2, item 9), lockwasher (11), (Table 2, item 6) and nut (12)

NOTE

Insure gladhand bracket (9) is parallel with frame rail (7).

n. Drill 5/16 inch (7.9 mm) diameter hole through crossmembe (8) with cap-

(13) as a template.

R e a r gladhand bracket installation

F i g u r e 7.