Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES

Page 2-6. Figure 2-3(2.1) is added after Figure 2-3(2) as fol-

Page 2-10, paragraph 2-13b. The warning is superseded as

lows:

follows:

Warning: Wear a respiratory mask at all times during

drilling to prevent rock drill dust from entering the lungs.

Wear safety glasses while drilling to prevent eye damage

from flying particles. Wear hearing protection while drill-

ing to prevent ear damage due to excessive noise.

Page 3-3. Chapter 3, Section III is superseded as follows:

Figure 2-3(2.1). Controls and instrumenls (for units equipped with

retrofit kit).

Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES

3-5. Introduction.

3-6. Explanation of Table Entries.

a. General. Tables 3-l and 3-2 (PMCS Table) have

a . Item Number Column. Numbers in this column are

been provided so you can keep your equipment in good op-

for reference. When completing DA Form 2404 (Equip-

erating condition and ready for its primary mission.

ment Maintenance and Inspection Work-sheet), include the

item number for the check/service indicating a fault. Item

b. Warnings and Cautions. Always observe the

numbers also appear in the order that you must do checks

WARNINGS and CAUTIONS appearing in your PMCS

and services.

table. Warnings and cautions appear before applicable

procedures. You must observe these WARNINGS and

b. Interval Column. This column tells you when you

CAUTIONS to prevent serious injury to yourself and oth-

must do the procedure in the procedure column. BE-

ers or to prevent your equipment from being damaged.

FORE procedures must be done before you operate or