SECTION V. UNIT MAINTENANCE PROCEDURES

TM 5-2590-512-13&P SECTION V. UNIT MAINTENANCE PROCEDURES 4-16. Connecting Link Replacement (Universal Drive Interface). This task covers: a. Removal b. Installation Initial Setup Tools: Equipment Conditions: General Mechanic's Tool Kit Auger Drive Unit removed from 5180-00-177-7033 SEE and placed on ground (para. 4-15 c). Materials and Parts: One cotter pin a. Removal. 1. Remove cotter pin (1) from clevis pin (2). Discard cotter pin (1) 2. Remove clevis pin (2) from connecting link (3). 3. Remove connecting link (3) from drive unit (4). b. Installation. NOTE Link (3) can be incorrectly installed into Auger Drive Unit (4) bracket. Correct installation requires link pin stop (5), be located on hydraulic hose side (6) of Auger Drive Unit (para 2-7). 1. Position connecting link (3) into place in Auger Drive Unit (4). Align holes in connecting link (3) to holes in Auger Drive Unit (4). Install oblong head clevis pin (2) thru side of Auger Drive Unit (4) that has metal pin stop angle (7) welded in place. 2. Push clevis pin (2) through holes in both brackets and ensure oblong clevis pin head is seated flush with pin stop (7) on Auger Drive Unit (4). 3. Insert new cotter pin (1) thru end hole in clevis pin (2) and spread ends. FOLLOW ON TASK. Install Auger Drive Unit on SEE vehicle (para 4-14). END OF TASK 4-17