b. Attach Auger Drive Unit

TM 5-2590-512-13&P b. Attach Auger Drive Unit. 1. Position Auger Drive Unit (1) on ground near dipper end (2) so that Auger hex shaft is away from SEE and hoses are on driver's side. Move dipper (2) into place and install link pin (3). Install link pin (3) into side of link with pin stop and seat oblong head against pin stop. Install lynch pin (4). 2. Move lynch pin (4) into locked position. 3. Tie bucket control cylinder linkage (5) to dipper arm bracket (6) with 6 ft. rope (7). c. Removing And Storing Bucket Hoses. 1. Disconnect both 30 inch backhoe bucket cylinder hoses (8) and (9) at quick disconnect fittings (10). Use rags to catch fluid and wipe fittings clean. 2. Loop hoses (8,9) and couple quick disconnect fittings (11) together over the dipper cylinder (12). 3. Remove two nuts (14) at hose clamp (13) and remove top half of hose clamp (13). 4. Install coupled hose assembly (8,9) so that female part of quick disconnect fitting (11) seats into lower half of hose clamp (13). 5. Install top half of hose clamp (13) and nuts (14). Tighten nuts to 3-5 lb. ft. (4-7 N•m). NOTE Installation of hoses into clamp is correct when hoses are secured and not moveable. 4-14