d. Conclusion

TM 5-2590-512-13&P 12. Thoroughly clean driver's and curbside boom cylinders (1,2), where safety Warning labels are to be installed, to remove dirt, oil, and moisture. Ensure area is dry. 13. Install one label (3) to each boom cylinder (1,2). 14. Check and tighten all fittings (4), clamps (5), retainers (6) on boom and dipper installed from Kit. 15. Check hydraulic reservoir fluid level in SEE vehicle and replace any fluid lost during installation. (Reference SEE TM Series 5- 2420-224). NOTE Clean up fluid spills on fittings, hoses, and around area. d. Conclusion. 1. Start SEE vehicle engine. 2. Visually examine kit installation parts for leaks from hoses at fittings. If there are any leaks, shut down SEE engine and tighten fittings. 3. Pull bucket control lever towards you. Ensure bucket curls towards operator (see para 2-2 Controls). 4. Move bucket control lever away from you. Ensure bucket uncurls away from operator. NOTE If controls work in reverse, hoses were not crossed during installation. Check steps in Kit installation procedures. 5. Operate bucket controls thru full range of motion and have assistant look for hose binding or stretching. Adjust clamp if necessary (see NOTE on previous page). NOTE This completes one-time conversion kit installation. SEE may be switched from Earth Auger Assembly use to Backhoe Bucket use, quickly, and easily. 4-12