b. Kit Installation

TM 5-2590-512-13&P NOTE Original Setup - Hoses (2, 10) cross on top side of boon. Kit Install Setup - Hoses (9, 15) cross under boom elbow. b. Kit Installation. NOTE SEE vehicle has backhoe bucket attached during Conversion Kit installation. CAUTION Start all fittings and hose connections by hand to avoid stripping threads. Use drip pans or shop rags to catch spilled hydraulic fluid. 1. Remove (crossed over) existing metal tube (2) under dipper cylinder (1) 2. Unscrew and disconnect fitting at each end of metal tube (2). Loosen hold-down bolts of two existing hose clamps (3) and (4). Remove and discard metal tube (2). 3. Assemble adapter (5) into male quick disconnect fitting (6). Install adapter assembly (5 and 6), into driver side hose (7) coming from rear of SEE. 4. Install 30 Inch hose (8) to Curb side bucket cylinder hose (9) where metal tube (2) was removed. (Thin 30" hose (8) has a female quick disconnect fitting on one end). 5. Remove remaining metal tube (10). 6. Assemble fitting adapter (11) into female quick disconnect fitting (12). Install fitting adapter assembly into curb side hose (13) coming from rear of SEE. 7. Install 30 inch hose (14) into driver side bucket cylinder hose (15). 8. Fasten top half of tube clamp (3) closest to rear SEE vehicle by tightening bolt (17) 4-9