|
| |
Back
3-7. Auger Center Point Replacement. | Up
TM-5-2590-512-13P Earth Auger Assembly Model 1650EH-MS Manual | Next
CHAPTER 4 UNIT MAINTENANCE |
TM 5-2590-512-13&P
WARNING
Prior to opening any hydraulic lines or fittings shut down SEE engine and move all SEE vehicle
hydraulic controls and pedals through their full range of motion to relieve system pressure.
To prevent serious injury or death from unexpected auger rotation disconnect auger hydraulic
lines at quick-disconnect fittings at Auger Drive Unit.
1.
Relieve system pressure. Disconnect hydraulic hoses at Auger Drive Unit quick disconnect fittings. Use
rags to catch drippings.
2.
Remove any excess mud and dirt from the auger center point.
3.
Remove nut (1), bolt (2), and center point (3) from the Auger.
b. Replacement
1.
Install center point (3), bolt (2), and nut (1) to Auger.
2.
Tighten nut to 14-18 Ib.ft (19-24 N•m).
3.
Connect both auger hydraulic hoses at the quick-disconnect fittings. Use rags to catch drippings and clean
fittings.
FOLLOW ON TASKS
Check level of hydraulic fluid in SEE vehicle reservoir (TM series 5-2420-224).
END OF TASK
3-8
|
