3-6. Auger Teeth Rotation or Replacement

TM 5-2590-512-13&P NOTE Install hex pin (4) thru side of auger hollow shaft (1) where raised anti- rotation pin stops are located. Ensure rectangle head of hex pin (4) rests inside of pin stop. 2. Use assistant and align both hex shafts so that pin holes will be in line. Slide Auger hollow hex shaft (1) over solid hex Auger Drive Unit shaft (6) and stop when hex pin holes line up. 3. Insert rectangle head hex pin (4) through aligned holes in Auger hex hollow shaft (1) and Auger Drive Unit hex shaft (6). Install hitch pin clip (3) with loop end pointing toward Auger Drive Unit (5). For safety reasons hitch pin clip is not tethered (to prevent dropping or loosing), so use care when removing or installing. 4. Wipe dirt from quick disconnects fittings and connect hydraulic hoses. 5. FOLLOW ON TASK Check level of hydraulic fluid in SEE vehicle reservoir (TM Series 5-2420-224). END OF TASK 3-6. Auger Teeth Rotation or Replacement. This task covers: a. Removal b. Installation Initial Setup Tools: Equipment Conditions: SEE vehicle Bll SEE vehicle engine off Adjustable wrench Item #16. Hydraulic System Depressurized 5120-00-264-3796 Materials and Parts: Replacement Auger teeth in Bll., Rags a. Removal. WARNING Prior to opening any hydraulic lines or fittings shut down SEE engine and move all SEE vehicle hydraulic controls and pedals through their full range of motion to relieve system pressure. To prevent serious injury or death from unexpected auger rotation, disconnect auger hydraulic lines at quick disconnect fittings at top of Auger Drive Unit. 3-6