|
| |
Back
SECTION IV. OPERATOR'S MAINTENANCE TASKS | Up
TM-5-2590-512-13P Earth Auger Assembly Model 1650EH-MS Manual | Next
b. Removal (Rough ground) |
TM 5-2590-512-13&P
WARNING
Hydraulic pressure remaining after SEE engine is off could cause unexpected auger rotation
resulting in serious injury or death. Prior to separating quick disconnect fittings, release system
pressure by operating all auger controls thru full range of motion (para 2.2).
Display auger by separating both quick-
disconnect fittings on hydraulic hoses
located on boom. Expect some fluid to
fittings and use rags to control spilling.
5.
Separate both quick-disconnect fittings on
both hydraulic hoses (1) located at Auger
Drive Unit (2).
6.
Remove any excess mud and dirt from the
top area the Auger (4).
7.
Remove the Hitch Pin Clip (5) and slide out
hex pin (6).
8.
Lift and slide Auger (4) away from Auger
Drive Unit (2).
9.
Store Hex Pin (6) and Hitch Pin clip (5) on Auger (4) output shaft.
WARNING
If moving to next excavation site, lift and transport Auger, with a suitable lifting
device, and set into bed of companion vehicle. Tie down to secure.
3-3
|
