Click here to make tpub.com your Home Page

Page Title: Home Page

• OPERATOR, ORGANIZATIONAL, DS AND GS MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
• SAFETY PRECAUTIONS
• HAMMER, PILE DRIVER, SELF-POWERED DIESEL DRIVEN, W/FUEL OIL TANK AND LUBRICATING OIL TANK
• Maintenance Forms and Records
• Table 2-1. Maintenance and Operating Supplies
• Table 2-1. Maintenance and Operating Supplies (Cont)
• Figure 3-6A. Lubricating oil lines and Pump removal installation
• Figure 3-7A. Fuel lines ,fuel tank ,fuel pump, and fuel pump drive housing
• Maintenance Forms and Records (Cont)
• Table of Contents
• LIST OF ILLUSTRATIONS
• Chapter 1: INTRODUCTION
• Figure 1-1. Diesel pile hammer, right-rear, three quarter view.
• Section II. DESCRIPTION AND DATA
• Differences in Models
• Chapter 2: INSTALLATION AND OPERATING INSTRUCTIONS
• Figure 2-1. Separately packed components.
• Section II. MOVEMENT TO A NEW WORKSITE
• Section III. CONTROLS AND INSTRUMENTS
• Section IV. OPERATION UNDER USUAL CONDITIONS
• Stopping
• FIGURE 2-7. Bleeding the hydraulic system.
• FIGURE 2-8. Engaging the starting device.
• Section V. OPERATION UNDER UNUSUAL CONDITIONS
• Chapter 3: OPERATOR AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
• Table 3-1. Preventive Maintenance Checks and Services.
• Figure 3-1. Fuel filter assembly, removal and installation
• Section V. TROUBLESHOOTING
• Section VI. LUBRICATION SYSTEM
• Section VII. FUEL SYSTEM
• Section VIII. HYDRAULIC CONTROL SYSTEM
• Figure 3-9. Hydraulic hose, receiver, and ransmitter, removal and installation.
• Section IX. STARTING DEVICE
• Section X. DRIVING HEAD AND ADAPTER
• Figure 3-11. Starting device, exploded view.
• Figure 3-12. Pile contours fitting driving head.
• Chapter 4: SHIPMENT, ADMINISTRATIVE STORAGE, AND DEMOLITION TO PREVENT ENEMY USE
• Other Demolition Methods
• Chapter 4: DIRECT AND GENERAL SUPPORT MAINTENANCE
• Section IV. TROUBLESHOOTING
• Chapter 4: REPAIR INSTRUCTIONS
• Section III. FUEL SYSTEM
• Figure 6-3. Fuel pump, exploded view.
• Fuel Pump Drive System
• Figure 6-5. Fuel pump drive system and lower cylinder, exploded view.
• Figure 6-6. Fuel injector.
• Section IV. CYLINDERS AND RAM
• Figure 6-9. Upper cylinder, exploded view.
• Recoil Dampener
• FIGURE 6-10. Ram, anvil, and recoil dampener, exploded view.
• Section V. HYDRAULIC CONTROL SYSTEM
• Figure 6-12. Hydraulic transmitter and relief valve, exploded view
• Relief Valve
• Appendix A: REFERENCES
• Appendix B: BASIC ISSUE ITEMS LIST
• Section II. BASIC ISSUE ITEMS
• Appendix C: MAINTENANCE ALLOCATION CHART
• Explanation of Columns in Section IV
• Section II. MAINTENCE ALLOCATION CHART
• Section II. MAINTENCE ALLOCATION CHART (Cont)
• Section III. SPECIAL TOOL AND SPECIAL TEST EQUIPMENT REQUIREMENTS
• Appendix D: REPAIR PARTS LIST
• Explanation of Columns
• Special Information
• Section II. PRESCRIBED LOAD ALLOWANCE
• Section II. PRESCRIBED LOAD ALLOWANCE (Cont)
• SECTION III - REPAIR PARTS FOR ORGANIZATIONAL MAINTENANCE
• GROUP 01 ­ ENGINE
• GROUP 01 ­ ENGINE (Cont)
• GROUP 01 ­ ENGINE (Cont)
• GROUP 03 ­ FUEL SYSTEM
• GROUP 03 ­ FUEL SYSTEM (cont)
• GROUP 22 ­ MISCELLANEOUS BODY, CHASSIS, OR HULL AND ACCESSORY ITEMS
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACCUUM CONTROLS
• GROUP 74 ­ CRANES, SHOVELS, AND EARTH MOVING EQUIMENT
• GROUP 74 ­ CRANES, SHOVELS, AND EARTH MOVING EQUIMENT (Cont)
• SECTION V ­ REPAIR PARTS FOR DS AND GS MAINTENANCE
• GROUP 01 ­ ENGINE
• GROUP 01 ­ ENGINE (Cont)
• GROUP 01 ­ ENGINE (Cont)
• GROUP 01 ­ ENGINE (Cont)
• GROUP 01 ­ ENGINE (Cont)
• GROUP 01 ­ ENGINE (Cont)
• GROUP 03 ­ FUEL SYSTEM
• GROUP 03 ­ FUEL SYSTEM (Cont)
• GROUP 03 ­ FUEL SYSTEM (Cont)
• GROUP 03 ­ FUEL SYSTEM (Cont)
• GROUP 03 ­ FUEL SYSTEM (Cont)
• GROUP 03 ­ FUEL SYSTEM (Cont)
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACUUM CONTROLS
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACUUM CONTROLS (Cont)
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACUUM CONTROLS (Cont)
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACUUM CONTROLS (Cont)
• GROUP 43 ­ HYDRAULIC, FLUID, AIR AND VACUUM CONTROLS (Cont)
• GROUP 74-CRANES, SHOVELS AND EARTH MOVING EQUIPMENT
• GROUP 74-CRANES, SHOVELS AND EARTH MOVING EQUIPMENT (Cont)
• Figure D-1. Upper cylinder.
• Figure D-2. Lower cylinder.
• Figure D-3. Air intake cover.
• Figure D-4. Ram, anvil, and recoil dampener.
• Figure D-5. Lubricating oil pump.
• Figure D-6. Lubricating oil filter.
• Figure D-8. Starting device.
• Figure D-9. Fuel injector, lines, and fittings.
• Figure D-10.
• Figure D-11. Pump drive.
• Figure D-12. Fuel and lubricating tank.
• Figure D-13. Fuel filter.
• Figure D-14. Starting fluid injector.
• Figure D-16. Hydraulic transmitter and relief valve.
• Figure D-17. Hydraulic receiver.
• Figure D-18. Driving head and adapter.
• Section VII, INDEX- FEDERAL STOCK NUMBER AND REFERENCE NUMBER
• CROSS-REFERENCE TO FIGURE AND ITEM NUMBER
• CROSS-REFERENCE TO FIGURE AND ITEM NUMBER (Cont)
• CROSS-REFERENCE TO FIGURE AND ITEM NUMBER (Cont)
• CROSS-REFERENCE TO FIGURE AND ITEM NUMBER (Cont)
• INDEX
• INDEX (Cont)
• THE METRIC SYSTEM AND EQUIVALENTS
• TM-5-3895-265-14
• Distribution;
• blank page
• By Order of the Secretary of the Army:
• Recommended Changes To Equipment Technical Publications