|
| |
TM 9-2320-364-20-2
2-1415
(1) Remove ten screws and
sunshield from instrument panel.
(2) Pull top of instrument panel towards
steering wheel.
(3) Disconnect wire 1016 from
horn button.
(4) Disconnect connector MC92.
(5) Set multimeter select switch to
ohms.
(6) Is continuity measured on wire 1016
between horn connector MC92,
terminal A and horn button?
(a) If there is no continuity, repair
wire 1016 (see schematic
Fig 2-36) or notify DS
Maintenance.
(b) If continuity is measured,
wire 1016 is OK.
(7) Connect wire 1016 to horn button.
(8) Install horn button.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive elecrical circuits, a direct short
may result. Damage to equipment, injury or
death to personnel may occur.
|
