| |
TM 10-3930-664-24
3.
Remove outer thrust washer (10), bearing (11),
and inner thrust washer (12) from shaft (6).
4.
Remove snap ring (13) from ring groove.
5.
Remove clutch end plate (14), six inner discs
(15), and six outer discs (16) from shaft (6).
6.
Compress disc washers (19) and remove snap
ring (17) using pliers. Remove retainer (18).
NOTE
Disc washers are installed as a set. Do
not
intermix
with
sets
from
other
clutches. Replace disc washers as a
set.
7.
Remove five disc washers (19) and wear plate
(20) from shaft (6).
8.
Turn clutch over and tap shaft (6) with a soft
head hammer to remove clutch piston (21).
9.
Remove and discard seals (22, 23).
4-60
|
