TM 10-3930-664-24 22. Press   bearings   (10,   9)   into   gear   and   bearing assembly (12).  Bearings must be flush with face of gear on both sides. 23. Carefully install gear and bearing assembly (12) onto shaft (27).  Align gear teeth with clutch inner discs.        Press    down    on    gear    and    bearing assembly  until  fully  seated.    Do  not  force  this operation. 24. Install  inner  thrust  washer  (8),  bearing  (7),  and outer thrust washer(6) onto shaft (11). 25. Press bearing (5) onto shaft (11).  Bearing has a shield in it which must face up. 26. Using pliers, install snap ring (3) into ring groove (4). 27. Install new piston rings (1).  Grease rings to aid installation into transmission housing. FOLLOW-ON MAINTENANCE: Install clutch assemblies (para. 4-20) END OF TASK 4-58