| |
TM 10-3930-664-24
5.
Remove drive (9) and spacer plate (10) from
housing (4). Remove and discard seal (11).
6.
Remove housing from vise.
7.
Tip housing (4) as shown. Remove two springs
(12), retainer plugs (13), and balls (14).
8.
Place housing (4), geroter end down, on a clean
soft cloth.
9.
Remove retaining ring (15) from housing (4)
using a thin bladed screwdriver. Use care not to
damage surfaces.
10.
Lift spool and sleeve assembly up far enough to
free seal gland bushing (16). Remove bushing
from housing (4).
3-150
|
