TM 10-3930-664-24 2-109. BRAKE PEDAL ASSEMBLY ADJUSTMENT This task covers: Adjustment INITIAL SETUP: Tools and Test Equipment: General Mechanics Tool Kit (1, App.  E) A. ADJUSTMENT 1. Remove master cylinder cover (1) from ROPS frame by removing screws (2) and washers (3). 2. Back off nuts (4) to allow rod adjustment. 3. Screw rods (5) into master cylinders (6) until rods bottom on cylinders. 4. Back off rods (5) between 1/16 and 1/8 inch. Tighten nuts (4). 5. Ensure that adjustment of rods is equal and that pivot is level. 6. Install master cylinder cover (I) onto ROPS frame using screws (2) and washers (3). FOLLOW-ON MAINTENANCE: None END OF TASK 2-297