| |
TM 10-3930-664-24
5.
Turn flange yoke (2) over and place on tube
stock. Carefully press on end of cross assembly
(1) so that remaining bearing (4) moves out of
flange yoke.
6.
Remove flange yoke (2) from cross assembly
(1).
7.
Repeat steps 3 through 6 to remove cross
assembly (1) from shaft assembly (3).
8.
Using a soft drift, tap outside of first bearing (9)
to loosen snap ring (10). Remove snap ring.
9.
Turn slip yoke (8) over and remove opposite
snap ring (10).
NOTE
Use tube stock with I.D. of 1.5 inches
to support flange yoke and shaft
assembly.
10.
Place slip yoke (8) in an arbor press with a piece
of tube stock beneath it. Position slip yoke with
grease fitting (11) up.
CAUTION
Ensure cross assembly (7) is straight
when pressing out bearings. If cross
assembly is cocked, bearing will
score walls of cross holes and ruin
slip yoke.
11.
Place a solid plug on upper bearing (9) and
press through to release lower bearing.
12.
Turn slip yoke (8) over and place on tube stock.
Carefully press on end of cross assembly (7) so
that remaining bearing (9) moves out of slip
yoke.
13.
Remove slip yoke (8) from cross assembly (7).
14.
Remove bearing trunions (12) from cross
assembly (7) by prying lockwire from slots in
bearing trunions and sliding bearings from cross
assembly.
2-279
|
